Frog Legs makes casters and forks for many different wheelchair manufacturers.  Each section below will cover a bearing location by fork or caster, any bearing options and any tools you may need. If you are not seeing what you are looking for or if you have any questions, please do not hesitate to contact us. 

Frog Legs Wheelchair Front Caster Bearings

Frog Legs make following casters:

1. Frog Legs EPIC Aluminum Narrow Cout Caster
2. Frog Legs EPIC Aluminum Wide Softroll Caster
3. Frog Legs Aluminum Double Softroll Caster
4. Frog Legs EPIC Aluminum Big Rig 6x2 Softroll Caster (contact us)

Most Frog Legs Casters use a 5/16" or 8mm axle.  Much less common is a 3/8" or 9.5mm axle used with TiLite Wheelchairs. 

Frog Legs 8mm Axle Front Caster Bearings:

 

Frog Legs 3/8" Axle Front Caster Bearings:

 

Frog Legs Wheelchair Fork Bearings

Fork Legs Makes forks with and without bearings.  This section here is for Frog Legs forks that have bearings in them.  Frog Legs uses two bearing in their forks. To figure out which one you have measured the stem of the fork, it is either going to be 12mm or 1/2".  See below for the right tools.  You can also contact us and we can look it up by wheelchair. Frog Legs forks are listed here:

1. Frog Legs BIG-RIGS Fork
2. Frog Legs Phase 2 Hybrid Fork
3. Frog Legs Phase One Fork
4. Frog Legs Pro Sport Fork

Frog Legs 12mm Stem Fork Bearings:

Frog Legs 1/2" Stem Fork Bearings:

To remove the fork bearings you will also need snap ring pliers. 

Other Tools

These are tools that you may want to consider if you are planning to do regular maintenance on your wheelchair.

Questions

If you are not seeing what you are looking for or if you have any questions, please do not hesitate to contact us.

Videos and instructions can be found in our Support Area.